Little more help

[Rixy1987]

:rolleyes: i got another little prob hehe,

there is a pic attached to this notes can any more tell me what the name of these pipes are ?? and where i could get another set from ?? plz

these r off a 1.3L maestro, they r the pipes from the engine to the heater these r found under the dash if thats any help ???


karl :confused: :banghead:

[H48HPE]

I know you could get them from rover at one time, but I think they either went NLA or were very expensive.

they don't look too bad, are you sure it was the pipes that were leaking? it can sometimes just be the gasket joint onto the matrix.

if you cant buy from rover anymore, then the only option would be to buy from a scrapyard or get the old set patched up some how, or remanufacture something from copper pipe etc.....

[mgmti]

The part is called Flange Plate and Pipes
P/N BAU5650 or JEP10006

Probably both NLA.

regards,
Patrick

[maestro vans]

I patched mine by cleaning the holed areas and soldering them up. I also built a new set from a length of 15mm copper pipe 6x 45degree bends and 2 couplings .
I hacksawed the flange off with enough to get the 15mm couplings on and made an exact copy using the 45 degree bends. It works a treat!
Go find that blowtorch, flux and solder Good Luck!!!

[talkingcars]

or use copper pipe and bending springs.........